User`s guide

888-24-228-G-00 rev.B • 07/13
6 of 15
FRONT OF
WORKSURFACE
FRONT OF
WORKSURFACE
FRONT OF
WORKSURFACE
a b
3
2
1x
16x
3/8"
(10 mm)
5/32"
(4 mm)
Ø 5/32" (4 mm) Ø 1/8" (3 mm)
Set-up Steps
Drill holes into bottom of work surface.
Drill the 16x holes into bottom of work surface 3/8" (10 mm) deep.
TIP: To ensure proper depth, place a piece of tape on the drill bit
3/8" (10 mm) from the tip.
Drill this 1x hole into bottom of work surface 5/32" (4 mm) deep.
TIP: To ensure proper depth, place a piece of tape on the drill bit
5/32" (4 mm) from the tip.
Make sure template is located properly and that it is square with the worksurface.
Then tape the template in place.