User`s guide

888-24-228-G-00 rev.B • 07/13
3 of 15
827-178-00
Minimize Lift Strength BEFORE:
-Removing Mounted Equipment
-Shipping the Cart
-Storing the Cart
Install Stop Screw BEFORE:
-Shipping the Cart
-Storing the Cart
To Minimize Lift Strength
and Install Stop Screw:
1. With cart upright, lower
worksurface to lowest
position.
2. Turn adjustment nut at
bottom of riser
counter-clockwise until it
stops (Adjustment may
require 40-60 revolutions).
3. Install Stop Screw. Follow
Installation Instructions
provided with Cart.
Safety
WARNING! Stop screw is pre-installed in this product to secure it in the compressed position during
shipping and installation. DO NOT REMOVE THIS SCREW UNTIL INSTRUCTED TO DO SO IN THESE
INSTRUCTIONS. Make sure this screw is in place before starting installation. Failure to follow these
instructions may cause lift engine to expand rapidly and may result in equipment damage and or
personal injury. If the phillips head stop screw is not installed in this location, contact customer care
before continuing with installation.
DO NOT REMOVE SCREW!
IMPORTANT!
Save this stop screw and instructions. Install stop screw when shipping or storing this product.
Failure to follow these instructions may cause lift engine to expand rapidly and may result in
equipment damage and or personal injury.