User`s guide

888-24-228-G-00 rev.B • 07/13
11 of 15
11
a
bc
Set-up Steps
Remove the stop screw to allow the worksurface to raise and
lower before installing equipment.
After you remove the stop screw,
release the hand brake and move
the worksurface up to highest level.
After worksurface is raised to it's highest
level, Install all equipment.
IMPORTANT!
Save this stop screw and instructions. Install stop screw
when moving, shipping or storing this product. Failure
to follow these instructions may cause lift engine to
expand rapidly and may result in equipment damage
and or personal injury.
CAUTION! Make sure you leave 20”
(508mm) of slack in all equipment
cables to allow the worksurface to raise
up it’s full 20” (508mm). Failure to allow
enough slack in equipment cables may
cause cables to get pulled, equipment
to fall o desk and may result in
product damage and or personal
injury.