User guide

ManualsBrandsErgotron ManualsOffice Furniture97-853

888-97-353-G-00 rev. A • 09/14

1/9

ABCD

14mm (9/16")

StyleView® SV43/44 Envelope Drawer

1x 1x

< 2 lbs (1 kg)

M4 x 12mm

User Guide

User's Guide - English

Guía del usuario - Español

Manuel de l’utilisateur - Français

Gebruikersgids - Deutsch

Benutzerhandbuch - Nederlands

Guida per l’utente - Italiano

Användarhandbok - svenska

ユーザーガイド : 日本語

用户指南 : 汉语

M3 x 25mm

For Medication Only.

Total weight capacity per drawer.

CAUTION: Close worksurface before opening drawers. Open only one drawer at a time. Do Not

push cart when drawers or worksurface are open. Failure to follow these instructions may cause

the cart to be unstable.

WARNING

IMPACT HAZARD!

MOVING PARTS CAN CRUSH AND CUT.

Minimize Lift Tension BEFORE:

· Removing Mounted Equipment.

· Shipping Cart

· Storing Cart

To Minimize Lift Tension

1. Lower worksurface to lowest position.

2. Turn adjustment nut at top of riser

counterclockwise until it stops

(Adjustment may require 40-60 revolutions).

Failure to heed this warning may result in

serious personal injury or property damage!

For More information and instructions refer to product

guide at http://4support.ergotron.com or contact

Ergotron Customer Care at 1-800-888-8458.

822-052

14mm (9/16”)

For the latest User Installation Guide please

visit: www.ergotron.com

Summary of content (9 pages)

PAGE 1
User Guide StyleView® SV43/44 Envelope Drawer For the latest User Installation Guide please visit: www.ergotron.com User's Guide - English Guía del usuario - Español Manuel de l’utilisateur - Français Gebruikersgids - Deutsch Benutzerhandbuch - Nederlands Guida per l’utente - Italiano Användarhandbok - svenska ユーザーガイド : 日本語用户指南 : 汉语 < 2 lbs (1 kg) Total weight capacity per drawer. For Medication Only.
PAGE 2
5.3" 12.8" 10.7" (134 mm) (324 mm) (272 mm) 5.4" (138 mm) Top View 12" (308 mm) 13" (329 mm) 11" (280 mm) 15.6" (395 mm) 12.6"- 24.4” (320-620 mm) Side View 1 d a Turn off all mounted equipment. Front View b c Disconnect Power System from power source. Turn power system off by holding down the AC Outlet Power button for 1 - 3 seconds. Power light will shut off. Disconnect Power from Drawer. Powered Carts Non-Powered Carts ON OFF 2/9 888-97-353-G-00 rev.
PAGE 3
2 Attach the Travel Stop bracket to the lift engine to keep the drawer from hitting the base. a 3 1x M3 x 25mm b Remove plug cover. 888-97-353-G-00 rev.
PAGE 4
Slide the drawer only half way onto the bottom tracks of the top drawer. 5a 4/9 Plug the cable on the bottom drawer into the jack on the bottom of the drawer above it. b Slide the drawer completely onto the bottom tracks of the top drawer. 888-97-353-G-00 rev.
PAGE 5
6 Remove the top drawer(s). 7 Secure the bottom drawer by attaching the two screws. 2x M4 x 12mm 8 Replace the top drawer(s). 888-97-353-G-00 rev.
PAGE 6
9a Reconnect drawer power. Powered Carts Non-Powered Carts ON OFF b Replace top cover on drawer. 6/9 888-97-353-G-00 rev.
PAGE 7
10 Adjustment It is important that you adjust this product according to the weight of the mounted equipment as described in the following steps. Any time equipment is added or removed from this product, resulting in a change in the weight of the mounted load, you should repeat these adjustment steps to ensure safe and optimum operation. Adjustments should move smoothly and easily through the full range of motion and stay where you set it.
PAGE 8
11 NOTE: User should change Master Personal Identification Number (PIN) upon receipt of cart. 1x Ensure that the main power system batteries are installed and functioning. The power does not need to be turned on at the power system user interface. Lost Master PIN Contact Ergotron Customer Care for instructions. All PINs may vary in length from 4 – 7 digits.
PAGE 9
888-97-353-G-00 rev.