User Manual

Instructions 100-D16-B02

1. Make sure the small hex set screw at the rear

of the base is backed out enough to allow the pole

to seat down completely. Insert pole into base.

Tighten sets crew with the small 3mm Allen Key

provided.

2. Loosen ratchet handle attached to the cross bar

(Ratchet handle must be on the right side of the(Ratchet handle must be on the right side of the

pole) Making sure the groove in the cross bar is

facing upwards, slide clamp assembly over the

pole and set at your desire height. Tighten handle..

3. With the silver release button facing towards

the top of the monitor, attach the quick release

pivot to the back of each monitor with the

screws pscrews provided.

4. Place each monitor on the horizontal bar by

tipping it back approximately 45 degrees and then

down until the silver release button engages the

grooves and clicks into place.

Left/Right and Up/Down: Grasp monitor with both hands and adjust to desired position. Note: pivots

may be tight at first but with the weight of the monitor, the screen will tilt up, down, left and right.

Tension Adjustment: Tighten the 5mm bolt on the right side of the pivot with the Allen key provided.

To remove monitors from cross bar: From the bottom: take the weight of the monitor in one hand and

tip it back slightly while using the other hand to lift the top of the silver release button. LIft up and back-

this motion will release the monitor from the stand.

PAGE 1
I nst r uct i ons100D16B02 1. Mak esur et hesmal l hexsetscr ewatt her ear oft hebasei sback edoutenought oal l owt hepol e t oseatdowncompl et el y . I nser tpol ei nt obase. Ti ght enset scr ewwi t ht hesmal l 3mm Al l enKey pr ov i ded. 2. Loosenr at chethandl eat t achedt ot hecr ossbar ( Rat chethandl emustbeont her i ghtsi deoft he pol e)Mak i ngsur et hegr oov ei nt hecr ossbari s f aci ngupwar ds, sl i decl ampassembl yov ert he pol eandsetaty ourdesi r ehei ght . Ti ght enhandl e. . 3.