System Manual
Table Of Contents
- Contents
- 1 General Notes
- 2 Definitions
- 3 Components
- 4 Start-up and Preparation
- 5 Attaching the ECG System to the Patient
- 6 Cleaning and Disinfection Instructions
- 7 Maintenance Information
- 8 Disposal
- 9 Technical Specifications
- 10 Electromagnetic Compatibility (EMC) DIN EN 60601-1-2
6 Cleaning and Disinfection Instructions
40 |
40
201000401000 / Rev 04
6.1.2 Disinfection
Clean the 1-channel transmitter before disinfecting it.
Recommended disinfectant: Isopropyl alcohol (IPA), 70 % solution, spray
• Apply IPA spray to the surface from a distance of 15 to 20 cm until the entire surface is wet.
• Allow the solution to remain on the treated surface for at least 1 minute.
• Dry the treated surface with a clean cloth.
• Dampen a clean cloth with distilled water.
• Wring excess liquid from the cloth.
• Wipe the exterior surfaces of the 1-channel transmitter.
• Use another clean cloth to dry the surface of the 1-channel transmitter.
6.2 Adapter
6.2.1 Cleaning
Recommended cleaning agent: Isopropyl alcohol, 70 % solution (IPA)
• Prepare the cleaning solution according to the manufacturer's instructions.
• Dampen a clean cloth with the selected cleaning solution.
• Wring excess liquid from the cloth and squeeze until dry.
• Wipe the exterior surfaces of the adapter until all visible soil has been removed.
6.2.2 Disinfection
Clean the adapter before disinfecting it.
Recommended disinfectant: Isopropyl alcohol, 70 % solution (IPA spray)
• Apply IPA spray to the surface from a distance of 15 to 20 cm until the entire surface is wet.
• Allow the solution to remain on the treated surface for at least 1 minute.
• Dry the treated surface with a clean cloth.
• Repeat steps 1 to 3.
• Dampen a clean cloth with distilled water.
• Wring excess liquid from the cloth.
• Wipe the exterior surfaces of the adapter.
• Use another clean cloth to dry the surface of the adapter.