User's Manual

8
1-1
3x4mm Set Screw
3x4mm Set Screw
* When installing the Start Shaft
Bearing Block Assembly, be sure
the Bearing Block is positioned so
the Bushing faces upward toward
the starter hex adaptor, with the
bearing toward the Clutchbell
Assembly.
Starter Hex Adaptor
*Start Shaft Bearing Block
Start Shaft
Complete Assembly
Clutch Bell Assembly
..........1 pc
3x6mm Socket Head Bolt
...1 pc
3mm Flat Washer
.........1 pc
CLUTCH BELL/START SHAFT ASSEMBLY
1-2
TAIL DRIVE PINION/BEARING BLOCK ASSEMBLY
Install the Lower Bearing Block so the
bearing face is toward the bottom:
Install the Upper Bearing Block so that
the bearing is toward the top:
Note: Be sure to allow a slight amount of
clearance between the Start Hex
Adaptor and the Bearing Block to
prevent binding.
Tail Drive Pinion
Bearing Blocks
Tail Drive Pinion
with Shaft
Front Tail Belt Pulley
(Install Flat Side Up)
3mm Flat Washer
3x6mm Socket Head Bolt
Complete Assembly
UP
UP
Bearing
Bearing
Use Threadlock
Use Threadlock