Manualshelf

User's Manual

ManualsBrandsErgocraft Contract Solutions ManualsMotorized Toy CarErgocraft Contract Solutions Ergocraft Contract Solutions Motorized Toy Car Ergo
31323334353637383940
32
6-1
UPPER SERVO TRAY INSTALLATION
RADIO INSTALLATION SUGGESTIONS
Be sure to install four rubber servo grommets and eyelets to each servo prior to
installation. When securing the servos to the helicopter, be sure not to over-
tighten the mounting screws.
All servo rods contained in this kit have been pre-adjusted to fit JR servos. If you
are installing a different brand radio system, please adjust the rod lengths to the
correct dimensions as listed in these instructions.
When adjusting control rods, be sure to adjust each universal link the same
amount so as not to unthread one link too far.
It is suggested that both the receiver and gyro amplifier be isolated from vibration
by wrapping them in foam, then securing them to the model using double-sided
servo tape.
Be sure to keep all servo lead wires, etc., away from all servo arms, rods, and
sharp edges of the helicopter’s mechanics. Group these wires together after final
installation using small nylon wire ties.
3x8mm Socket Head Bolt
......4 pc
3x8mm Socket Head Bolt (4 pc)
Upper Servo Tray