User's Manual

5-3
TAIL CENTER HUB ASSEMBLY
28
3x3mm Set Screw
.......2 pc
3mm Lock Nut
........2 pc
Tail Blade Holder Bearing
........4 pc
2x8mm Socket Head Bolt
........4 pc
3x15mm Socket Head Bolt
.......2 pc
3mm Lock Nut
........2 pc
2mm Hex Nut
........4 pc
* Be sure to note direction of Tail Rotor Blades during assembly.
5-4
TAIL BLADE HOLDER ASSEMBLY
Tail Output Shaft Hole
Tail Blade Holder w/Ball
(Outside)
3x15mm Socket
Head Bolt
2x8mm Socket
Head Bolt
Tail Blade Holder
w/o Ball (Inside)
Rotation
2mm Hex Nut
3mm Lock Nut
Tail Rotor Blade
Rotation
Two Sets Required
* Be certain to apply Locktite to the two
3x3mm set screws and attach securely to
the tail output shaft so the set screws
engage into the tail output shaft hole.
Failure to secure this assembly properly
can result in tail rotor failure during flight.
Tail Center Hub
Tail Blade Holder Bearing
(4pc)
Tail Slide Ring Assembly
3x3mm Set Screw (2pc)
Use Threadlock
Use Threadlock
*
3mm Lock Nut
(2 pc)
*