User's Manual

11
2-1
UPPER MAIN FRAME SECTION ASSEMBLY
Note: Be sure to use the two shorter Body
Mount Standoffs for this installation.
Note: Both the Clutch Bell/Start Shaft Assembly
(Step 1-1) and the Tail Drive Pinion/
Bearing Block Assembly (Step 1-2) are
temporarily installed at this time. These
assemblies will be adjusted and secured
in Step 3-2.
3x8mm Socket Head Bolt
..........21 pc
Body Mounting Standoffs Shaft
.......2 pc
3mm Flat Washer
..........11 pc
2.6x8mm Self Tapping Screw
..........4 pc
3x10mm Socket Head Bolt
..........1 pc
Tail Control
Rod Guide
3x10mm Socket Head Bolt
Body Mounting Standoff: Short
Bearing side must face upward*
Body Mounting
Standoff: Short
3x8mm Socket Head Bolt
(21 pc)
3mm Flat Washer
(11 pc)
*Bearing side must
face downward
Servo Mounting Plates
Upper Main Frame
2.6x8mm Self Tapping
Screw (4pc)
Upper Main Shaft Bearing Block
Position so the side
of the bearing block
that has the bearing
flush with the flange
is upward.
UP
Lower Main Shaft Bearing Block
UP
Bearing Flush
with Flange
Bearing
Bearing
Bearing Flush
with Flange
Position so side of
the bearing block
that has the bearing
flush with the flange
is downward.
Use Threadlock On
All Screws