Motorized Toy Car User Manual

3-4.1

.46 COOLING FAN INSTALLATION

3-5

.32-.36 ENGINE MOUNT ATTACHMENT

Note: If you are building the Ergo .46 3D Version proceed to Step 3-5.1.

Longer Distance

Shorter Distance

Note: If you are building the Ergo .32-.36 Version, proceed to Step 3-5.

Note: It will not be necessary to use the four 3x5mm

Socket Head Bolts included in this screw bag.

Note: It will be necessary to shorten the Crankshaft of

the engine to allow clearance. Test fit the Fan

Assembly to determine the correct amount to be

removed. On the Thunder Tiger Pro .46 Heli

Engine, it will be necessary to remove 1/2" from

the tip of the Crankshaft.

*It is recommended that a Piston Locking Tool be used to

properly secure the Cooling Fan Assembly to the engine.

3x15mm Socket Head Bolt

3mm Flat Washer

........4 pc

3mm Serrated Washer

........4 pc

Top

Bottom

Motor Mount Direction

Engine Mount .32-.36

3mm Serrated

Washer (4 pc)

3x15mm Socket

Head Bolt

3mm Flat

Washer (4 pc)

Nut Supplied with Engine

* Revolution 1003 Piston Locking Too

(Purchased Separately)

It is important to note the proper direction that the motor mount

is installed to achieve the correct alignment of the engine.

Aluminum Cooling Fan

(Ergo .46)

Use Threadlock

......4 pc