Motorized Toy Car User Manual

1-5
ELEVATOR ARM ASSEMBLY
10
2x8mm Flat Head Screw
Steel Joint Ball
......2pc
Elevator Arm Pin
......2pc
..........2pc
2x8mm Flat Head Screw
Steel Joint Ball
Elevator Arm Front
Elevator Arm Pin
Steel Joint Ball
Swashplate A Arm
Swashplate A
Arms
Edge of Work Bench
Elevator Arm
Tap-in gently with
a small hammer.
Elevator Arm Rear
2x8mm Flat
Head Screw
Caution: Be sure to note correct Swashplate A Arm installation direction.
Elevator Arm (Front)
Elevator Arm (Rear)
Marked Side Out
Swashplate A
Arm
Swashplate A
Arm
Marked Side In
After assembly, check to be sure the
Fuel Tank Clunk can move from the
bottom to the top of the tank without
touching the back wall of the Fuel Tank.
Fuel Tank
Silicone Fuel Tubing
(not incuded)
Connects to Engine Carburetor
* Trim before installation to a length of 58mm
Nipple
Tank Grommet
* Silicone Tube (Small)
Fuel Tank Clunk
Silicone Fuel Tubing
(not included)
Connects to Muffler Pressure Tap
1-6
FUEL TANK ASSEMBLY