Datasheet

4430e/LK/28.11.2016
TECHNICAL DATA SHEET ergo.
®
4430
Retaining Compound, high strength
Physical Properties (liquid product)
Chemical Base: Ester of Methacrylic Acid
Colour: green
Viscosity at 25°C Brookfield RVT
100 – 200 mPas spindle 2, 20 rpm
Density at 25°C: 1.07 g/cm³
Max. thread diameter: M 12
Max. gap filling: 0.15 mm
Flash point: > 90°C
Shelf life: 1 year at room temperature
Physical Properties (cured product)
Measured on M10 x 20 bolt - grade 8.8 black phosphatized - nut 0.8d (no on-torque)
Initial strength after: 5 - 10 minutes
Functional strength after: 30 - 40 minutes
Final strength after: 3 - 6 hours
Loose-break torque: > 25 Nm DIN 54454
Prevailing torque: > 40 Nm
Shear strength: > 25 N/mm² DIN 54452
Thermal range: - 55°C up to +150°C
WARRANTY INFORMATION - PLEASE READ CAREFULLY
The information contained herein is offered in good faith and is believed to be accurate. However, because conditions and methods of
use of our products are beyond our control, this information should not be used in substitution for customer's tests to ensure that KISLING
products are safe, effective, and fully satisfactory for the intended end use. KISLING sole warranty is that the product will meet the
KISLING sales specifications in effect at the time of shipment. Your exclusive remedy for breach of such warranty is limited to refund of
purchase price or replacement of any product shown to be other than as warranted. KISLING specifically disclaims any other express or
implied warranty of fitness for a particular purpose or merchantability. Unless KISLING provides you with a specific, duly signed
endorsement of fitness for use, KISLING disclaims liability for any incidental or consequential damages. Suggestions of uses should not be
taken as inducements to infringe any particular patent.
Description
High strength adhesive for the retaining of bearings in bushes and wheels on axles
without any cleaning. Good curing properties, even at deep temperatures (> +5°C)
and on inactive metal surfaces. Certified acc. to NSF ANSI 61 for use in commercial
and residential potable water systems not exceeding 82° C. NSF P1 listed for use in
food processing areas.
Note: This is a regional approval. Please contact us for more information and
clarification.