Datasheet

Page 3/6
Safety data sheet
according to 1907/2006/EC, Article 31
Printing date 16.09.2017 Revision: 16.09.2017Version number 1
Trade name: ergo 4202
(Contd. of page 2)
45.2.31
-
Storage class (TRGS 510, Storage of hazardous substances in non-stationary containers):
10-13
-
7.3 Specific end use(s)
No further relevant information available.
SECTION 8: Exposure controls/personal protection
-
Additional information about design of technical facilities:
No further data; see item 7.
-
8.1 Control parameters
-
Ingredients with limit values that require monitoring at the workplace:
The product does not contain any relevant quantities of materials with critical values that have to be monitored
at the workplace.
-
Additional information:
The lists valid during the making were used as basis.
-
8.2 Exposure controls
-
Personal protective equipment:
-
General protective and hygienic measures:
The usual precautionary measures are to be adhered to when handling chemicals.
-
Protection of hands:
Protective gloves on prolonged contact with skin.
Check protective gloves prior to each use for their proper condition.
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation
-
Material of gloves
Find below a list of appropriate protective gloves for chemical surrounding:
.
Permeation time / penetration time: = 480 minutes (DIN EN 374):
Naturlatex I , Nr. 0395 oder 0403
Chloropren Nitril I, Nr. 0727
Nitril I, Nr. 0730, 0732, 0733, 0736, 0737, 0738, 0739 oder 0836
Viton, Nr. 0890
Butyl II, Nr. 0897
Butyl, Nr. 0898
.
Permeation time / penetration time: = 240 minutes (DIN EN 374):
Chloropren Nitril II, Nr. 0717
Nitril VI, Nr. 0754
Nitril V, Nr. 0764
.
of KCL company (e-mail: [e-mail]).
.
The recommendation is based exclusively on the chemical compatibility and the test according to EN374
under laboratory conditions.
Requirements can vary according to the use. Therefore, please always take into account the glove supplier’s
recommendations.
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality
and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the
resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the
application.
-
Penetration time of glove material
Permeation time / penetration time: see above (material of gloves)
The exact break trough time has to be found out by the manufacturer of the protective gloves and has to be
observed.
-
Eye protection:
Avoid contact with the eyes.
GBGEN
(Contd. on page 4)