Datasheet

4100e/LK/ 28.11.2016
TECHNICAL DATA SHEET ergo.
®
4100
Thread Locker, high strength
Physical Properties (liquid product)
Chemical Base: Diester of Methacrylic Acid
Colour: red / fluorescent
Viscosity at 25°C, Brookfield RVT
4000 – 7000 mPas spindle 3, 2,5 rpm
1200 – 1800 mPas spindle 3, 20 rpm
Density: 1.11 g/cm³ at 25°C
Max. thread diameter: M 36
Max. gap filling: 0.25 mm
Flash point: > 100°C
Shelf life: 1 year at room temperature
Physical Properties (cured product)
Measured on M10 x 20 bolt - grade 8.8 black phosphatized - nut 0.8d (no on-torque)
Initial strength after: 10 - 20 minutes
Functional strength after: 2 - 4 hours
Final strength after: 3 - 6 hours
Loose-break torque: > 20 Nm (M10) DIN 54454
Prevailing torque: > 35 Nm (M10)
Shear strength: > 20 N/mm² DIN 54452
Thermal range: - 55°C up to +150°C
WARRANTY INFORMATION - PLEASE READ CAREFULLY
The information contained herein is offered in good faith and is believed to be accurate. However, because conditions and methods
of use of our products are beyond our control, this information should not be used in substitution for customer's tests to ensure that
KISLING products are safe, effective, and fully satisfactory for the intended end use. KISLING sole warranty is that the product will meet
the KISLING sales specifications in effect at the time of shipment. Your exclusive remedy for breach of such warranty is limited to refund
of purchase price or replacement of any product shown to be other than as warranted. KISLING specifically disclaims any other
express or implied warranty of fitness for a particular purpose or merchantability. Unless KISLING provides you with a specific, duly
signed endorsement of fitness for use, KISLING disclaims liability for any incidental or consequential damages. Suggestions of uses
should not be taken as inducements to infringe any particular patent.
Description
High strength thread locker which fastens stud bolts with excellent resistance
against chemicals and temperature influence. Difficult to disassemble bonded
parts, even with tools. Certified acc. to ANSI/NSF Standard 61 for use in
commercial and residential potable water systems not exceeding 82° C.
NSF P1 listed for use in food processing areas.
Note: This is a regional approval. Please contact us for more information and
clarification.