Autopetfeeder Manual

9. What if there is no power at my house at the time of feed?

If there is no power supply at the time of feed, the feeder will not dispense food at that particular feeding schedule. The

programs will remain in the timer and will continue to operate as programmed when the power supply comes on.

10. There are no instructions to set the seconds feature on the timer?

The ON/ AUTO/ OFF button in the Program mode acts as the second’s button. If you have any difficulty setting the timer,

please call 1-888-ERGOSYS.

11. The food keeps dispensing all the time.

Please check if the power cord from the auto pet feeder is plugged in the timer side of the timer. If the cord is plugged

on the POWER side, the feeder will run continuously. Please check if the timer is in the ON mode. If the problem persists,

Please call 1-888-ERGOSYS.

12. What is the third circle on the timer for?

The third circle on the timer indicates the daylight saving time and gets activated when you set the timer for the

daylight saving feature.

13. The food is ground and broken down when it reaches the feeding bowl.

Please check if the size of pet feed you use in the feeder is within the size specified. This could be a result of over sized

feed. Please check food size table below and find out if your feed size matches.

ARGE FEEDER

Minimum Timer Setting = 1 Second

OZS Timer Setting

3 1 minute

6 2 minute

9 3 minute

12 4 minute

15 5 minute

MEDIUM FEEDER

Minimum Timer Setting = 1 Second

OZS Timer Setting

1 ½ 1 minute

3 2 minute

4 ½ 3 minute

6 4 minute

8 5 minute

Maximum Food size is

7/8" diameter

(ACTUAL SIZE)

Maximum Food size is

3/4" diameter

(ACTUAL SIZE)