User guide

EG_GenPro2xe_1003_UG_005_UK Page 39 / 63
Descriptions and non-contractual illustrations in this document are given as an indication only.
ERCO&GENER reserves the right to make any modifications.
Dct_427_00
The available signals on the RS232 serial link are:
TX data (CT103/TX) : Data emission,
RX data (CT104/RX) : Data reception,
Request To Send (CT105/RTS) : Request to send,
Clear To Send (CT106/CTS) : Ready to send,
Data Terminal Ready (CT108-2/DTR) : Data terminal ready,
Data Set Ready (CT107/DSR) : Data set ready,
Data Carrier Detect (CT109/DCD) : Signal detection (optional) and Buzzer output (by default),
Ring Indicator (CT125/RI) / 3.8V : Call indicator (optional) and 3.8V power supply for GenBlue 15e
or Gen10400 (by default).
Normalized signals of a RS232 serial link
The RS232 interface was designed to allow a certain flexibility in the use of the serial interface signals. In
fact, after the setting (see command AT+IFC), the modem can work in 3-wire mode (using only the signals
TX, RX, GND), but the use of the signals TX, RX, GND, CTS, RTS is required for a GPRS application, which
is not the case for the signals DTR, DSR, DCD/Buzzer and RI/3.8V that may not be used.
7.3.2 Pins description
Signal
Sub HD Connector
Pins numbers
I/O
RS232
Standard
Description Added function
CTXD/CT103 2 I TX Transmit serial data
CRXD/CT104 6 O RX Receive serial data
CRTS/CT105 12 I RTS Request To Send
CCTS/CT106 11 O CTS Clear To Send
CDSR/CT107 7 O DSR Data Set Ready
CDTR/CT108-2 8 I DTR Data Terminal Ready
CDCD/CT109 1 O DCD Buzzer output (1*)
CRI/CT125 13 O RI
Power supply 3.8V
(1*)
CT102/GND 9 Ground
(1*) By default