User guide

EG_GenPro2xe_1003_UG_005_UK Page 18 / 63
Descriptions and non-contractual illustrations in this document are given as an indication only.
ERCO&GENER reserves the right to make any modifications.
Dct_427_00
3.2.2 Cables
According GenPro ordered, different cables described below will be delivered (refer to table 1.1).
3.2.2.1 2-wire micro FIT cable GenPro 22e
The 2-wire micro FIT cable allows to power the modem.
Black wire (GND)
5mm tinned copper wire
Molex connector
Red wire (+VDC)
Fuse 2.5A/250V
(5 x 20 mm)
View from cable side
Component Characteristics
4-pin Micro FIT connector Supplier: MOLEX
Cable Length  1.5m
Wirel Tinned copper 24 x 0.2 mm
Section : 0.75 mm²
Fuse F2.5A L250V
3.2.2.2 4-wire micro FIT cable GenPro 23e
One of the two following cables is provided
The 4-wire micro FIT cable allows to power the modem and to use the 2 signals Input and Output.
Component Characteristics
4-pin Micro FIT connector Supplier: MOLEX
Cable Length  1.5m
Wire Tinned copper 24 x 0.2 mm
Section : 0.75 mm²
Fuse F2.5A L250V
OUTPUT 2
OUTPUT 1
Molex connector
Green wire (OUTPUT)
Black wire (GND)
5mm tinned copper wire
Red wire (+VDC)
Fuse 2.5A/250V
(5 x 20 mm)
View from cable side
Orange wire (INPUT 1)