User guide

EG_GenPro30e_1006_UG_002_UK Page 19 / 37
Descriptions and non-contractual illustrations in this document are given as an indication only.
ERCO&GENER reserves the right to make any modifications.
In the section "Ports (COM and LPT)", the COM port to send AT commands is AT Command Port (UMTS)
(COM13). As the number of the port is virtual, it can change depending on the PC installations.
You can close the window of Peripheral management system.
Use a communication software like HyperTerminal of Windows
Configure the COM port of the DTE as follows:
▪ Data rate: 115200 bps,
▪ Data bits: 8,
▪ Parity: None,
▪ Stop bits: 1,
▪ Flow control: hardware.
Send the command
AT ↵ . In HyperTerminal, the modem must reply OK.