User guide

EG_GenPro30e_1006_UG_002_UK Page 15 / 37
Descriptions and non-contractual illustrations in this document are given as an indication only.
ERCO&GENER reserves the right to make any modifications.
5 Using the modem
5.1 Starting with the modem
5.1.1 Mounting the modem
To mount the modem on a support, use the fixing brackets as described hereunder.
5.1.2 Installation of the modem
To install the modem, it is recommended to do the following operations with the modem turned off:
- Remove the SIM card cover on the rear side.
- Carefully insert the SIM card into the reader.
- Push the SIM card until hearing a "clic" that ensures its correct positioning.
- Put the SIM cover back.
- Connect the GSM antenna to the SMA connector.
- For the connection to the DTE, connect the USB cable.
- Connect the supply cable to the continuous and regulated power source.
- Connect the supply cable to the modem and turn on the external power supply (the GSM LED
must switch on).
The modem is now ready.
5.1.3 USB Driver installation
It is necessary to use the Drivers available on our website when using and installing the GenPro 30e
modem associated to the USB port.
We advise you to install the driver before switching the modem on.
The installation of several GenPro 30e, on a PC with several ports USB is not supported.
On a PC, only one GenPro 30e will be able to be connected at the same moment.
Fixing brackets
Note:
- Must be fixed on a
flat surface
- Max. height of the
screw head: 2 mm