Technical data

Òîâà ñå ñèãíàëèçèðà ñ ìèãàíå íà ëàìïà ALARM. Äîðè è

òåìïåðàòóðàòà äà ñïàäíå ïîä 90 – 95

íå ïîñëåäâà íîâî

âêëþ÷âàíå. Íåîáõîäèìà å íàìåñà îò îáñëóæâàùèÿ ãîðåëêàòà

ïåðñîíàë. Ñëåä îòñòðàíÿâàíå íà ñìóùåíèåòî â íîðìàëíàòà

ðàáîòàòà, ïóñêàíåòî íà ãîðåëêàòà ñòàâà ÷ðåç èçêëþ÷âàíå è

âêëþ÷âàíå îòíîâî íà ãîðåëêàòà. Òîâà ìîæå äà ñòàíå èëè ÷ðåç

ïðåâêëþ÷âàòåëÿ POWER íà êàïàêà íà ãîðåëêàòà (òîé ïðåêúñâà

çàõðàíâàíåòî íà ëîãè÷åñêèÿ ìîäóë â ãîðåëêàòà è íóëèðà

àëàðìàòà) èëè ÷ðåç ñïèðàíå íà îáùîòî çàõðàíâàíå íà êîòåëà ÷ðåç

ãëàâíèÿ ìó øàëòåð.

B-2. CONSTRUCTIVE SAFETY RULES

· The process of ignition and burning is being monitored by a

microprocessor logistical module.

· There is an end limit switch on the burner’s frame and a special T-

figured detail which does not allow starting of the burner if it is not attached

to the boiler (for example when cleaning up the boiler). If during work

there is received a signal from the limit switch for bad mounting of the

burner, its work will be automatically stopped and this will be shown with

of lamp ALARM. After fixing the disturbance in the normal work, the

burner starts with its switching off and on. This can be done by the

POWER switch placed on the burner’s cover (it stoppes the feeding of

the logistical module in the burner and clears the alarm), or by stopping

the common power supply of the boiler through its main switch.

· The process of ignition and burning is being monitored by a photo sensor

and if does not ignite after few attempts (adjustable parameter), the

burner goes into stop-mode with activated alarm.

· If during work the pellets bring to end into the feeding bunker, the burner

goes into stop-mode with activated alarm.

· The flexible tube for transporting the pellets is transparent and made of

a special heat-resistant material.

· The customer’s access to the microprocessor logistical module’s program

is secured by a password. Only few parameters about the normal work

of the burner can be accessed by the customer.

· There have been used stickers, maximum showing the correct usage of

the burner.

The burner is provided with elements, securing the right burning of the fuel:

· Falling shaft – it stops the flow of pellets from the auger transporter to

the burner. This shaft is deep about 250 mm. Besides the transporter is

connected to the burner by a flexible hose, which is not full of pellets. In