Specifications

p 4
Eraser Company Inc. • Syracuse, NY USA • Ph: 315-454-3237 • [e-mail] • www.eraser.com • Fax [phone]
An optional tubing cutting blade is available (see
Optional Accessories).
NOTE: DO NOT use the tubing blade to cut wire as
this will severely damage the blade.
Place the unit on a sturdy workbench. A material
collection bin can be placed by the right/front corner
of the unit, to collect cut material as it exits the
WC601A.
NOTE: It is possible for the WC601A to be controlled
by an external device or process, by using the DB9
connector located on the rear panel of the unit.
Contact a sales representative for more details.
The WC601A may also be used with a tensioning
dereeler or an automatic pre-feed system. Use
of the Model DE700 Compensating Dereeler
is recommended. This device will improve the
accuracy and/or the productivity of the WC601A.
If using the DE700, or any other dereeling system,
place the dereeler to the left side of the WC601A,
approximately 24” (for elastic materials the distance
may be reduced) from the entrance bushing in a
straight line and align the exit pulley of the dereeler
with the entrance bushing of the WC601A. If using
the DE700, refer to the operating manual for further
set up details.
Insert the power cord into the IEC connector, and
plug the unit into a 120V 60 Hz mains supply. Use a
properly grounded mains supply.
DO NOT PLACE FINGERS OR APPENDAGES IN
OR NEAR OPENINGS IN GUARDS.
DO NOT RUN UNIT WITH INCORRECT LINE
VOLTAGE. REFER TO LABEL PLACED TO THE
RIGHT OF THE IEC CONNECTOR.
DO NOT ALLOW UNTRAINED OR UNQUALIFIED
PERSONNEL TO OPERATE UNIT.
DO NOT DEFEAT ANY OF THE SAFETY FEATURES
IMPORTANT: NO LIABILITY WILL BE INCURRED
BY THE ERASER CO. FOR INJURY, DEATH, OR
PROPERTY DAMAGE CAUSED BY A PRODUCT
WHICH HAS BEEN SET UP, OPERATED, AND/OR
INSTALLED CONTRARY TO ERASER’S WRITTEN
OPERATING MANUAL, OR WHICH HAS BEEN
SUBJECTED TO MISUSE, NEGLIGENCE, OR
ACCIDENT, OR WHICH HAS BEEN REPAIRED
OR ALTERED BY ANYONE OTHER THAN
ERASER, OR WHICH HAS BEEN USED IN A
MANNER OR FOR A PURPOSE FOR WHICH THE
PRODUCT WAS NOT DESIGNED.
OPERATING INSTRUCTIONS
DO NOT OPERATE TOOL UNTIL YOU HAVE READ
THOROUGHLY, AND UNDERSTAND COMPLETELY,
ALL INSTRUCTIONS, RULES, ETC., ON THESE
PAGES. THESE ARE IMPORTANT SAFETY
INSTRUCTIONS AND SHOULD BE KEPT FOR
FUTURE REFERENCE. CONTACT ERASER IF
INSTRUCTIONS ARE NOT CLEAR.
When the machine is powered up, the “splash”
screen will briey display:
THE ERASER COMPANY
 WC601A [rmwarerevisiondate]
SET-UP:
Check your shipment to be sure all items listed
under the Included Parts section are in the box. If
anything is missing, please let us know immediately.
!CAUTION:TheWC601Acomeswiththewire
blade installed. This blade is intended for use
onwireandisextremelysharp.Cautionmustbe
usedwhenremovingorinstallingtheblade.
NOTE: Use of the wire blade to cut tubing will result
in distorted cut ends
MODEL WC601A AUTOMATIC WIRE & TUBING CUTTER