Specifications

MODEL WC601A AUTOMATIC WIRE & TUBING CUTTER
TROUBLESHOOTING
Problem Possible Cause Possible Solution
Blade stuck in the closed
position
Blade hitting the cut bushing
Re-Install cut bushing (See the cut bushing installation
procedure)
Material doesn’t feed properly
Belt feed not adjusted
correctly
Tighten the belt feed adjusting knob clockwise to increase
tension (Do not over tighten, this will cause material to jam)
Cut bushing too small
Re-Install cut bushing (See the cut bushing installation
procedure)
Display not functioning
Blown fuse Replace with recommended fuse
Unit not powered up Turn power switch on, in the rear of the unit
Incorrect voltage supplied
Make certain the incoming voltage is correct and is NOT being
inuenced by large equipment upstream.
Poor quality of cut or no cut
Dull or chipped blades Dull or chipped blades must be replaced
Cut bushings not installed
correctly
Re-Install Cut bushings (See the Cut bushing installation
procedure)
Erratic cut lengths
Uneven Dereeler tension Make sure at high speeds, a power assisted dereeler is used
Feed belts not adjusted
correctly
Tighten the feed belt adjusting knob clockwise to increase
tension clockwise to increase tension
Cut bushing too small
Re-Install cut bushing (See the cut bushing installation
procedure)
Phone: [phone]
Fax: [phone]
Website: www.eraser.com
E-mail: info
@eraser.com
The Eraser Company, Inc.
PO Box 4961/ Oliva Drive
Syracuse, NY 13221, USA
Always Moving Forward
®
IR1555
REV 06/14
p 13