Specifications

p 12
Eraser Company Inc. • Syracuse, NY USA • Ph: 315-454-3237 • [e-mail] • www.eraser.com • Fax [phone]
BUSHING CHANGE OR REPLACEMENT:
! CAUTION: Be sure unit is unplugged and
the air line is disconnected before changing
bushings.
To change the entrance bushing, open the front
cover. Loosen the set screw in the entrance bushing
support with the 3/32” Allen wrench provided, and
slide the bushing out. Insert the desired entrance
bushing, aligning the at with the set screw and
tighten. Be sure the entrance bushing does not
come in contact with the feed belts.
To change the exit (cut) bushing, loosen the button
head cap screw holding the exit chute with the 3/32”
Allen wrench provided. Remove the exit chute by
sliding it to the right. Locate the set screw holding
the exit bushing. While holding the exit bushing,
insert the 5/64” Allen wrench into the front plate in
line with the exit bushing, and loosen the set screw.
Remove the bushing by sliding it out of the cut plate.
Slide the new exit bushing into the back of the cut
plate and align the ground surface of the bushing
with the ground surface of the cut plate. Using a
straight edge or at piece of metal, align the cutting
edge of the exit bushing with the surface of the cut
plate. The countersink should face the belts. Tighten
the set screw on the exit bushing. Reinstall the exit
chute assembly and close the front cover.
IMPORTANT: THE NEW BUSHING MUST BE
PROPERLY ALIGNED WITH THE CUT PLATE
TO ENSURE SQUARENESS OF CUT AND
BLADE AND BUSHING LIFE. IF THE BUSHING
PROTRUDES PAST THE CUT PLATE, SEVERE
DAMAGE TO THE CUT BLADE WILL OCCUR.
FEED BELT REPLACEMENT:
Loosen the set screws on the pulleys. Remove the
belts and pulleys from the spindles. Slide the new
belt onto the pulleys, reinstall spindles and tighten
the set screws on the ats of the spindles.
! CAUTION: Be sure to unplug the unit and
disconnecttheairsupplybeforeperformingany
maintenance.
!CAUTION:Employappropriateanti-static
proceduresanddeviceswhenassemblingor
disassemblingtheunit.
Check the cut bushing and blade for wear and
replace if dull. Due to the number of different
materials, the timing of checks will be determined
based on the material being run. Keep unit clean
and free of dust and debris. No lubrication or other
regular maintenance is required.
IMPORTANT: NO LIABILITY WILL BE INCURRED
BY THE ERASER COMPANY FOR INJURY,
DEATH, OR PROPERTY DAMAGE CAUSED BY A
PRODUCT THAT HAS BEEN SET UP, OPERATED,
AND/OR INSTALLED CONTRARY TO ERASER’S
WRITTEN OPERATING MANUAL, OR THAT HAS
BEEN SUBJECTED TO MISUSE, NEGLIGENCE,
OR ACCIDENT, OR WHICH HAS BEEN REPAIRED
OR ALTERED BY ANYONE OTHER THAN
ERASER, OR WHICH HAS BEEN USED IN A
MANNER OR FOR A PURPOSE FOR WHICH THE
PRODUCT WAS NOT DESIGNED.
MODEL WC601A AUTOMATIC WIRE & TUBING CUTTER