Manual

Toyota/Lexus
ERASING CODES
43 Chapter 5
ERASING CODES
•
Always observe safety precautions whenever working on a
vehicle.
•
Remove Code Reader from vehicle’s test connector before
erasing codes.
•
Erase codes only when all repairs have been completed.
Refer to “Toyota Erasing Procedures” or “Lexus Erasing
Procedures” for specific instructions for your year, make
and model.
•
After erasing codes, verify that repairs were successfully
completed. Start the engine and warm to normal
operating temperature. After normal operating
temperature is reached, turn off the ignition and repeat
the code retrieval procedure for your vehicle. If no codes
are retrieved, the repair(s) was successful.
NOTE: Removing fuses or battery cables may clear the memory
on the radio, clock, etc., or may enable the “Theftlock” feature
on the radio.
Toyota Erasing Procedures
Model Years Procedure
4 Runner 85-94 With ignition off, remove 15A “EFI’ fuse for 30 seconds.
Camry 85 With ignition off, remove negative battery cable for 30
conds.
86 With ignition off, remove 15A “ECU-B” fuse for 30 seconds.
87-93 With ignition off, remove 15A “EFI” fuse for 30 seconds.
Celica 86-95 With ignition off, remove 15A “EFI” fuse for 30 seconds.
Corolla 87-91 With ignition off, remove 15A “Stop” fuse for 30 seconds.
92-95 With ignition off, remove 15A “EFI” fuse for 30 seconds.
Cressida 83-89 With Super Monitor Display: With ignition off, remove
15A “EFI” fuse for 30 seconds.
87-88 With ignition off, remove 15A “EFI” fuse for 30 seconds.
89-92 With ignition off, remove 20A “EFI” fuse for 30 seconds.
MR2 85-87 With ignition off, remove 7.5A “AM2” fuse for 30 seconds.
88-95 With ignition off, remove 15A “EFI” fuse for 30 seconds.
Land 88-94 With ignition off, remove 15A “EFI” fuse for 30 seconds.
Cruiser
Paseo 92-95 With ignition off, remove 15A “EFI” fuse for 30 seconds.