Specifications

INTRODUCTION
The SODIR Model # BAR-106 and # BAR-206 countertop snack toasters offer
speedy toasting and finishing. The units are designed for commercial applications,
especially when small footprint is an issue. The snack toasters are constructed of
stainless steel and are equipped with quartz heating elements, a 4-position switch,
a 15'minute timer with hold position and a red pilot light. Model # BAR-106 comes
with one wire rack, while # BAR-206 comes with two of wire racks. Each rack has
a mounted-on door with a heat-resistant handle.
SPECIFICATIONS
Model Electrical Plug Configuration
BAR106/1 120V, 1PH, 1.1KW, 10A NEMA-5-15P
BAR106 208/240V, 1PH, 0.93KW, 4/5A NEMA-6-15P
BAR206/1 120V, 1PH, 1.65KW, 14A NEMA-5-15P
BAR206 208/240V, 1PH, 1.4KW.6/7A NEMA-6-15P
INSTALLATION
The SODIR snack toasters need to be connected to a grounded outlet of proper
voltage (208/240V or 120V) depending on the model. DO NOT place the unit in a
damp area or near steam source. Make sure that the back panel of the snack
toaster is not blocked.
OPERATION
The snack toasters are simple to operate. Turn the toaster on by rotating the
switch to one of the three following positions: "ALL ELEMENTS ON", "TOP
ELEMENTS ON", or "BOTTOM ELEMENTS ON". Turn the timer knob clockwise to
select the desired time. By turning the timer knob to the "HOLD" position indicated
by the marking "C" on the time dial, operate the unit in continuous mode. Put the
product on the wire rack and slide the rack into the unit. Always use the drip tray.