Specifications

Preheating
Select the preheating temperature by turning the thermostat knob
clockwise to the desired setting
–
usually
anywhere between
‘6’
and
‘8’
. The red indicator
light
will turn on. The preheat time will be approximately 10
–
15 minutes. When the preset temperature has been reached, the red indicator
light
will turn off.
Baking
After the preheat process is complete, you may adjust the temperature by turning the thermostat knob
to the
desired setting. The red indicator
light
will be on when unit is heating, and off after it has reached the preset
temperature.
The
SODIR
cr
epe machines can be used for a wide variety of foods. Baking times will vary depending food
products, temperature settings and desired results. After depositing batter to the top plate, use the T
-
shaped
wooden spreader provided with the machine to achiev
e uniform distribution of batter over the surface. It will
usually take thirty (30) seconds to a minute for the crepe product to bake to a golden brown on both sides. It is
recommended that the crepe be turned over approximately half way through baking.
To turn the crepe machine
‘
off
’
,
turn
the knob
counter
-
clockwise until it stops. It will point to the yellow dot at
the 12:00 o’clock position and
t
he red indicator
light
will go out.
CLEANING
WARNING: Disconnect (unplug) electrical power supply before
cleaning
Allow the crepe machine to cool
down to a safe temperature
before cleaning. Use a cloth dampened with a
soap and water mixture to clean the stainless steel housing and top plate. Clean the machine thoroughly at
the end of each day.
Failure to
do so may cause hard to remove build up. To remove build up on the top
plate, use an industry standard food service grade degreaser. For tough to remove carbon buildup, use a
commercially available carbon remover.
DO NOT spray the unit with any cleanin
g liquid before unplugging it
.
DO NOT allow water to drip into the housing
or
around the electrical components
.
DO NOT immerse in water
for cleaning.
You should i
nspect all parts on a regular basis to ensure that all is in proper working order. If a part
is
damaged, have the unit repaired by an authorized service agency prior to returning the unit to operation. If you
have trouble locatin
g a service agency in your area,
please
consult our website
at
http://www.equipex
.com/
, or
call
us at
1
-
800
-
649
-
7885 and ask for customer service.