User guide

Firewire CDRW Installation

For Win98SE, Me, 2000 and XP

(Note for Win98SE only: After plugging in the cable some system might

prompt you for Win98SE CD, in case you don’t have The Win98SE CD and the

wizard prompt you for:

b. NTMAP.SYS please type C:\WINDOWS\SYSTEM32\DRIVERS

c. NTMAPHLP.PDR please type C:\WINDOWS\SYSTEM\IOSUBSYS

IF the system did not prompt you for anything just follow the steps below)

1. Make sure the Firewire cable is securely attach from the back of the drive.

2. Make sure that power is attached and turned on.

3. Power on the system, on the Window Desktop, double click on the

MY COMPUTER icon.

4. Plug the Addonics Six Pin FIREWIRE-IDE cable into your computer’s

FIREWIRE port if the computer has a Six Pin Female Firewire port or

5. Plug the Six Pin Male Firewire cable from your computer to the Six Pin

Female Daisy Chain port of Addonics Firewire cable shown on Diagram 3.

6. Wait for a few seconds, your computer may blink for a moment as well.

7. Double Click on the “My Computer” icon if not open yet. Your Mobile

CDRW will appear as a CD drive icon.

You are now ready to use the CDRW Drive.

Addonics Technologies – Mobile CDRW Users Guide v4.0