Specifications

10
4.3 Auto-Scan Function
Hot Key:
[Scroll] → [Scroll] → [S] → [Esc] to BEGIN.
There is about 10 seconds for the initial time waiting.
Press the [Esc] key to STOP.
NOTE : [Esc] will stop the atuo-scan
operation and make the KMV jump to
the current scanning PC.
You can activate the Auto-Scan function by using the following two-step Hot Key
sequence. To send commands to the KVM Switch, press the [Scroll] key twice (Step 1), then
press [S] (Step 2). When you press the Auto-Scan hot key sequence, the KVM Switch
alternates between the two PCs and displays them on the monitor.
Each PC is display one of time interval from 5 ~ 60 seconds (The interval is adjustable) before
switching to the next. When you press any key on the keyboard, the Auto-Scan will stop and
the monitor screen will jump back to the original PC. During the Auto-Scan mode, the KVM will
ignore the mouse operation, if you move mouse you will not see the cursor move on the
screen.
Adjustable scan time interval setting ( 5 ~ 60 sec. )
Hot-key: Pressing the <Scroll >, <Scroll > then <S> and < n>
*n = 1~ 9
<n>
Scan time
interval
<n>
Scan time
interval
1 5 6 30
2 10 7 35
3 15 8 40
4 20 9 60
5 25