User`s manual

DemoKit-LG2 User’s Manual

7.4 Connecting and Starting

1. Switch SW1/S1 to ON to initiate flash programming mode.

Figure 54. Switch and Jumper Settings in Flash Programming Mode

SW1

Setting Mode

S1 ON Programming mode

S2 OFF UART6 select

S3 OFF OCD disabled

S4 OFF On-board debugging function

Jumper Setting Mode

JP1 1–2 closed Power supply via USB

JP2 Open Power supply via USB

JP3 Closed Clock supplied via CPLD

2. Connect the DemoKit-LG2 board to the host computer via the USB cable. If the connection was

already made, press the SW2 reset button to exit flash programming mode.

3. Start the FPL3 GUI.

Figure 55. GUI Software Main Window

4. Click Device → Setup to set the programming environment.

Figure 56. Device Setup Box: Standard Tab

5. On the Standard tab, click PRM File Read to open the Parameter File box.

6. Select 78F0397D.prm and then click

Open.