User`s manual

DemoKit-LG2 User’s Manual
48
7. How to Use the FPL3 Flash Programming Software
This section explains the basic operation of the FPL3 GUI for programming the DemoKit-LG2 board,
including how to start the system, execute the Autoprocedure (EPV) command, and program the target
device. Table 15 and Table 16 list the specifications for the series of operations described.
Table 15. Hardware Configuration of DemoKit-LG2
Base Board DemoKit-LG2
Target device
78K0/LG2
(
µ
PD78F0397D
)
Cloc
k
6 MHz
Volta
g
e level 5 V
Table 16. Software Configuration of FPL3
Parameter File µ78F0397D.PRM
Clock settin
g
6 MHz
(
multi
p
lied b
y
1
)
Port COM3
(
115200 b
p
s
)
O
p
eration mode Chi
p
Write HEX 78K0 LCD DEMO.hex
O
p
tion settin
g
Blank check before Erase
7.1 Installing the FPL3 GUI software
Install the FPL3 GUI software on the host machine you are using, by referring to CHAPTER 7
SOFTWARE INSTALLATION (if the software has not been installed yet).
7.2 Installing the Driver
Install the USB driver on the host computer as described in Section 5.2, Software Installation.”
7.3 Installing the Parameter File
The parameter file for the MCU is automatically stored in <FPL3 install-path>\PRM during FPL3
installation. Nevertheless, the newest version of the parameter file can be downloaded from the NEC
Electronics America web site (
http://www.am.necel.com/microcontrollers/devtools.php) and copied into
the <FPL3.EXE-install-path>\PRM subdirectory whenever a new version is available.