User`s manual

DemoKit-LG2 User’s Manual
Group/Item Option Description
Chip Subjects the entire flash memory area of the target device to rewriting
Bloc
k
S
p
ecifies a block of flash memo
r
y
to be rewritten
Area
Specifies an area to be rewritten. The Start/End list boxes display the Area
numbers where the flash memor
y
of the tar
g
et device is confi
g
ured.
Operation
Mode (some
modes not
available in
all devices)
Show Address
b
ox
Specifies whether numbers or addresses are displayed in the Start/End boxes. If
selected
,
addresses are dis
p
la
y
ed. If not selected
,
numbers are dis
p
la
y
ed.
Target Reset
Messa
g
e
—
Displays the window promoting the manual reset operation, even when the
reset si
g
nal cannot be connected to the tar
g
et cable.
• Advance Properties: The Advance tab contains command options and security flag settings.
Figure 49. Device Setup Box: Advance Tab
Table 12. Device Setup Box: Advance Properties
Group/Item Option Description
Blank check
before Erase
Performs a Blank Check before executing an Erase or Autoprocedure
(EPV) command. If the result of a blank check indicates OK, the Erase
command is not executed
Read verify
after Program
Sends write data from the programmer after execution of the Program and
Autoprocedure (EPV) commands, and then verifies the data against the data
written to flash memory
Security flag
after Program
Automatically programs the selected security flag after execution of the
Program and Autoprocedure (EPV) commands
Command
options
Checksum
after Program
Reads the flash memory checksum value of the target device after execution of
Program and Autoprocedure (EPV) commands; this value differs from the
value displayed in the Parameter Programming window
Disable Chip
Erase
Invalidates the Erase command in the entire flash memory area of the target
device and displays a warning stating that When chip erase is disabled, chip
cannot be erased and programmed anymore!” Caution: If the security flag is
set in the target device, erasing and writing to the device cannot be enabled.
Disable Block
Erase
Invalidates the Erase command in all blocks of flash memory selected under
Operation Mode in the Standard tab of the Device Setup box; this setting is
cleared b
y
the Erase command if chi
p
is selected under O
p
eration Mode
Security flag
settings
Disable
Program
Invalidates the Program and Erase commands in all blocks of flash memory
selected under Operation Mode in the Standard tab of the Device Setup box.
The Erase command for the entire flash memory area is valid. This setting is
cleared b
y
the Erase command if chi
p
is selected for O
p
eration Mode.
45