User`s manual

DemoKit-LG2 User’s Manual
42
6.3.2 Device Menu
The Device menu displays the programming commands.
Figure 47. Device Menu
6.3.2.1 Blank Check Command
The Blank Check command executes a blank check on the target device connected to the FPL3
programmer. If the target MCU’s flash memory has been erased, the blank check terminates
normally. If the flash memory has not been erased completely, the program displays a not blank
message, after which you will need to execute an Erase command.
6.3.2.2 Erase Command
The Erase command erases the flash memory of the MCU connected to the FPL3 programmer.
While the flash memory is being erased, the Action Log window displays the progress. Upon
completion, the GUI software displays the result of the command on the target device.
Execution of a
Blank Check command before an Erase command depends on the setting of the
Advance properties in the Device Setup box (Table 13).
6.3.2.3 Program Command
The Program command sends a specified user program to the target device and writes the
program to the device’s flash memory. During programming, the Action Log window displays
the progress. Upon completion, the GUI software displays the result of the command on the
target device.
Execution of a Verify command after execution of a
Program command depends on the
settings of the Advance properties in the Device Setup box (Table 12).