Specifications

- 19 - Hardware Installation Process
English
1
FDD
7,8)Floppy/ IDE1 / IDE2 Connector
(Primary/Secondary]
9)IDE3/IDE4 Connector
(RAID/ATA133,Green Connector)(**)
 Important Notice:
Please connect first harddisk to IDE1
and connect CD_ROM to IDE2.
The red stripe of the ribbon cable must be the
same side with the Pin1.
IDE3
1
IDE4
Important Notice:
1. The rad stripe of the ribbn cable must be the
same side with the Pin1.
2. If you wish to use IDE3 and IDE4, please use
it in unity with BIOS (either RAID or ATA133).
Then, install the correct driver to have proper
operation. For details, please refer to
the RAID manual.
If you want the detail information for “RAID“
setup , please refer to "chapter 5 Appendix"
..
..
.
6)NB_FAN
 If you installed wrong direction, the Chip Fan
will not work. Sometimes will damage the Chip
Fan. (Usually black cable is GND)
VCC
1
GND
IDE1
1
IDE2