Instruction manual

14 Equinox MEGAPORT Hardware Reference Manual
4. After making sure that the top of the board’s bracket is
aligned with the hole on the top of the expansion slot,
replace the screw which previously held the expansion slot
cover. Tighten the screw firmly.
5. Connect the interconnect cable on the newly installed board
to the J3 connector on the previously installed board located
to right of the new board.
6. If more than one additional MEGAPORT board is being
installed, repeat steps 1 through 5 for each board.
Note: If the computer has trouble finding the second MEGAPORT
board, suspect a faulty connection with the MEGAPORT 1" intercon-
nect cable. Remove the interconnect cable and reinstall it making
sure none of the pins are bent and all the pins are enclosed by the
interconnect cable.
Figure 2-5. Interconnecting multiple MEGAPORT boards