Instruction manual
Installing MEGAPORT Boards 9
Chapter 2
Installing MEGAPORT Boards
This chapter describes how to install MEGAPORT, MEGAPORT/2
and MEGAPORT/RS boards into a computer system. The following
topics are covered:
● The MEGAPORT Board
● EISA Installations
● Intermixing MEGAPLEX and MEGAPORT Boards
● Installing a Single MEGAPORT Board
● Installing Multiple MEGAPORT Boards
● PS/2 Type Hardware Configuration
● RS/6000 Hardware Configuration
● Installing the Round Cable
The MEGAPORT Board
Figure 2-1 is an illustration of the MEGAPORT boards. No hardware
configuration is required on the board. However, make careful note of
the J2 and J3 connector locations. J2 is the input connector and J3 is
the output connector. These connectors are used when more than one
MEGAPORT board is installed. Interconnections between boards are
not required when installing multiple MEGAPORT/2 or
MEGAPORT/RS boards.
Figure 2-1. MEGAPORT, MEGAPORT/2 and MEGAPORT/RS boards
MEGAPORT/2 and
MEGAPORT/RS
MEGAPORT