Instruction manual

Introduction 5
Chapter 3 - Connecting Devices to CS and FM Ports
Chapter 3 describes the procedures used to connect devices to
MEGAPORT CS boards (12CS, 24CS and the second 12 ports
on the 12LD+12CS) and MEGAPORT 12FM boards. Included
are wiring diagrams for assistance in building adaptors and
cables.
Chapter 4 - Connecting Devices to LD Ports
This chapter describes the procedures used to connect devices
to MEGAPORT LD boards (12LD, 24LD and the first 12 ports
on the 12LD+12CS). Included are wiring diagrams for assis-
tance in building adaptors and cables.
Equipment Checklist
A MEGAPORT package contains:
● MEGAPORT* Board
Installs in any 80286-, 80386- or 80486-based computer.
● 1" Interconnect cable (MEGAPORT only)
Used to connect multiple MEGAPORT boards together.
● EISA Jumper (MEGAPORT only)
For EISA bus computers.
● UNIX/XENIX Device Driver Kit
Provides the software and manual required for installing
MEGAPORT boards in systems running the UNIX System
V 3.2/386 operating system, the 286 or 386 SCO XENIX
operating system and compatible variants.
● UNIX STREAMS Device Driver Kit
Provides the software and manual required for installing
MEGAPORT boards in systems running the UNIX System
V Release 4 STREAMS operating system and compatible
variants.
● AIX-2 Device Driver Kit (MEGAPORT/2 only)
Provides the software and manual required for
installing MEGAPORT/2 boards in systems running IBM
AIX Version 2.
● AIX-3 Device Driver Kit (MEGAPORT/RS only)
Provides the software and manual required for installing
MEGAPORT/RS boards in systems running IBM AIX
Version 3.