Hardware reference guide

Equinox SST-4I/RJ Hardware Reference Guide 2
Use the following procedure to install your SST-4I/RJ Board.
Alternatively, you may follow the installation instructions presented
in your host system documentation.
1. Set the host computer system power switch to OFF and
disconnect the power cord.
2. Locate a free expansion slot.
3. Insert and secure the board firmly into the expansion slot.
4. Replace the power cord and turn the host computer system ON.
Equinox SuperSerial Technology (SST) RJ Boards are intelligent,
high-speed (up to 921.6 kbps) multiport boards providing high
performance serial I/O solutions for ISA bus systems. All port
interfaces are standard RS-232 with partial modem control (one
control signal out and two control signals in) and voltage surge
protection. (If your application requires EISA, PCI, Micro Channel
bus and/or full modem control, contact your Equinox reseller for
information on other SST products.)
SST Boards appear to the system host processor as memory. That is,
they are memory mapped devices. Each board is automatically
mapped into system memory at the time of device driver installation.
The device driver soft-configures all boards each time the system is
initialized (booted). See PN 560093 (Windows NT, Windows 95,
Novell AIO, and OS/2), PN 560084 (UNIX SVR3.2, SCO, and
XENIX) or PN 560085 (UNIX SVR4 STREAMS) for detailed
device driver information.
The SST board (shown in Figure 1 below) occupies a single ISA slot
in the host computer and provides the intelligent functions to "off-
load" the CPU serial communications processing tasks.
Overview
Figure 1. SST-4I/RJ Multiport I/O Board