Instruction manual

14 MEGAPLEX Hardware Reference Manual
5. After running the automatic configuration the system
CMOS contains the configuration of all adapters including
the MEGAPLEX/2. At this point, backup the new configura-
tion by selecting option 3, Backup configuration, from the
set configuration menu.
6. The new configuration is copied onto the Backup Reference
Diskette. After the backup is complete, remove the Backup
Reference Diskette and store it and the original Reference
Diskette in a safe place. Exit the POS configuration utilities
and reboot the system from the hard disk. The system
should boot normally and not display the 165 error message.
The device driver is now ready to be installed under the
booted operating system as described in the Software
Reference Manual.
RS/6000 Hardware Configuration
MEGAPLEX/RS only
After installing MEGAPLEX/RS boards, the board must be configured
using the IBM SMIT facility. Information on how to do this is pro-
vided in the AIX-3 Software Reference Manual.