Owner`s manual

Installation Instructions
5
PREPARE
BEFOR YOU BEGAINRE
HOT W ATER LINE
• The line may enter from Either side, rear or floor
within the shaded area shown in Figure F.
• The line may pass through the same hole as the
electrical cable and Drain hose. Or, Cut an additional
1-1/2" dia. hole to accommodate the water line.
If power cord with plug is used, water line Must not
pass through power cord hole.
Figure 6
W ater Line Connection
• Turn off the water supply.
• Install a hand shut-off valve in an accessible location,
such as under the sink. (Optional, but strongly recom-
mended and may be required by local codes.)
• Water connection is on the left side of the dishwasher .
Install the hot water inlet line, using no less than 3/8"
O.D. copper tubing. Route the line as shown in Figure F
and extend forward at least 18" from rear wall.
• Flush water line to clean out debris.
• The hot water supply line pressure must be 20-120 PSI.
CAUTION:
Opening the door will cause the dishwasher
to tip forward. Do not open the door until you are ready
to install the dishwasher . If it is
necessary to open the door, hold
the top of the dishwasher securely
with one hand and hold the door
with the other hand.
Cabinet Face
Shut-off
Valve
3" From Floor
18" From Wall
4"
From
Cabinet
1-1/2" Dia.
Hole
Hot
Locate set aside
2 Phillips screws
and 2 in
the literature package).
Locate and set aside the package containing
2 phillips head countertop mounting screws
and 2 additional toekickscrews(located in
the literature).
Adjust water heater for 120 F to 15 0 F temperature.