Owner`s manual

Installation Instructions
12
length for a total of 10 ft. to the factory installed hose.
Use 5/8" or 7/8" inside diameter hose and a coupler to
connect the two hose ends. Secure the connection
with hose clamps.
Figure 22
STEP 13 CONNECT DRAIN LINE
FOLLOW ALL LOCAL CODES AND ORDINANCES.
The drain hose molded end will fit 5/8", 3/4" or 1"
diameter connections on the air gap, waste tee or
disposer. Cut on the marked line as required for your
installation.
DRAIN LINE INST ALLA TION
• Connect drain line to air gap, waste tee or disposer
using either previously determined method.
Waste Tee Installation
Disposer Installation
Method 2- – High drain loop with waste tee or disposer
Disposer Installation
Figure 24
Figure 25
• Secure the drain hose to the air gap, waste tee or
disposer with clamps.
NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED
10 FEET FOR PROPER DRAIN OPERATION.
IMPOR T ANT –
When connecting drain line to
disposer, check to be sure that drain
plug has been removed. DISH-
WASHER WILL NOT DRAIN IF PLUG IS LEFT IN PLACE.
TIP: Avoid unnecessary service call char ges. Always
be sure disposer drain plug has been removed before
attaching dishwasher drain hose to the disposer.
Figure
23
Remove
Hopper
Plug
Cutting Lines
1"
3/4"
5/8"
IMPORTANT: Do not cut corrugated
portion of hose
Hose Clamp
Coupler
Fasten to underside
of countertop
32"
Min.
18"
Min.
Fasten to underside
of countertop
18"
Min.
Waste Tee Installation
If a longer drain hose is required,add up to 42 of f
Cutting Lines
IMPORTANT:Do not cut corrugated
portion of hose
Coupler
Hose Clamp
Hose Clamp
Method 1-Air gap with waste tee or disposer
Remove
hopper
plug