Compact Refrigerator REF 65L-16SS
General This appliance is intended to be used in household and similar applications such as – staff kitchen areas in shops, offices and other working environments; – farm houses and by clients in hotels, motels and other residential type environments; – bed and breakfast type environments; – catering and similar non-retail applications. This type of refrigerator is widely used in places such as hotels ,offices, student dormitories and houses.
voltage. The power plug should have its independent socket, adapter may cause the socket overheat. 2.Don’t store inflammable materials such as ether, benzine, LP gas and glue etc in the refrigerator. 3.Don’t splash water on the refrigerator, it may arouse malfunction or electric shock. 4.When gas leaks from its container. Don’t pull the plug out or in. it may arose sparks and fire calamities. 5.
cans with a flammable propellant in this appliance. Disposal 1. Old appliances still have some residual value. An environmentally friendly method of disposal will ensure that valuable raw materials can be recovered and used again. 2. The refrigerant used in your appliance and insulation materials require special disposal procedures. Ensure that none of the pipes on the back of the appliance are damaged prior to disposal.
thermostatic dial is the most suitable for general operation. 3.Defrost the freezing compartment whenever the layer of frost on the surface of the evaporator reaches 3 or 4 mm. When defrosting remove all food and set the thermostat at “OFF” position. Put the drip tray under the evaporator to collect melted water. After the frost has melted, discard the melted water and dry up the interior of refrigerator. The refrigerator can then be restarted by turning its thermostat to the desired setting.
Maintenance 1.While cleaning the refrigerator. pull out the electric power plug, rub carefully with a piece of cloth soaked with natural cleanser then wipe with clean water. The abrasive cleaning power, alkali cleansers, chemical cloth, thinner, alcohol, acid petroleum product and hot water are not suitable for cleaning the refrigerator, they may damage the painting cover and plastics. 2.The door gasket is dirty and fogged easily, so clean it frequently. 3.
4.The surface of the compressor becomes hot: The surface of the compressor may become hot under normal operation. Don’t touch it with hands. Methods of inspecting malfunction If any case of malfunction happens, please inspect and dispel it according to the methods shown in the following table.
Food frozen in the refrigerator Compartment Is the thermostatic dial set to the correct position? Have the foods stuff been put too crowded? Noises Is the refrigerator installed firmly? Has the refrigerator been struck by some other objects? Compressor Cannot stop automatically Are the foods stored too much at one setting? Are the doors opened too frequently or too long? If the above methods are not yet effective, please contact with the maintenance service department for help without any delay.
Every now and then check if the appliance is sufficiently ventilated (adequate air circulation behind the appliance). For household refrigerating appliances, in normal temperature conditions, please arrange the thermostat at the middle setting. Before loading the appliance with packages of fresh foods, make sure they are cooled to ambient temperature. Ice and frost layer increase energy consumption, so do clean the appliance as soon as the layer is 3-5 mm thick.
Remove the plastic covering from the top door hinge. Unscrew the three screws from the bottom bracket. Remove the foot from opposite side. Place to one side. Slide the fridge door down about 15cm [6"] and off the top hinge pin and lift away from the fridge. Screw the bottom hinge into place on the new side. Replace the other foot on the other side. Move the top hinge to the other side and screw it in. Slide the fridge door back on to the top hinge, making sure it’s the right way up.
