Installation Guide

level options
18
A. How to run WASH + DRY Cycle
1. Press POWER button
2. Press START
Default cycle is NORMAL - If required you can change to desired washing cycle based on
type of clothes by rotating the Program Dial knob.
1. Press POWER button
2. Press WASH Only button
3. Press START
1. Press POWER button
2. Press DRY Only button
3. Press START
B. How to run WASH Only Cycle
C. How to run DRY Only Cycle
Default cycle is NORMAL - If required you can change to desired washing cycle based on
type of clothes by rotating the Program Dial knob.
Default cycle is NORMAL and Sensor Dry - You can select Damp, Low or Extra for the desired
dry level. You can also select Time Dry for 60 minutes.
Only for wash settings
Ventless Mode
(Condensing)
An extra rinse can be addedd
by pressing “Wash+Dry” and
“Wash Only” at the same time.
An Extra rinse and 9 minutes
will be added to the cycle.
4. At the end of the DRY cycle, if the clothes are not completely dry or if the clothes have been in the
drum for some time, you can press the Refresh button to dry the clothes and prevent wrinkles.
*
*