Specifications

6. I want a pressurized hot and cold water system with a manual pump back up. A saltwater system is not
needed. I will want a Spectra (www.spectrawatermakers.com
) watermaker. I will probably want a small
PUR electric/manual watermaker as a backup. I believe 50 gals of water tankage should be adequate,
however if we don’t gain much savings in cost, weight, or space by reducing the water tanks size I will
stay with your standard and only fill them above 50 gals when entering an anchorage where it isn’t
appropriate to run the watermaker. Although I will want to use a heat exchanger on the genset I doubt
that alone will produce enough hot water daily therefore the calorifier(s) (probably two 9 gal units) will
also need heating elements see (www.isotherm.com).
7. One large opening port light on the outer hull across from the sinks. See Exhibit 10 (Catana 580).
8. One opening port light on stern bulkhead. No overhead hatches should be necessary.
9. Only if traction might be a problem I will want a carpet fully covering the galley sole, in sections, with
Velcro backing that can be easily removed for shaking and cleaning.
10. If feasible, I might want the galley sole raised to give persons standing in the galley a better view into
the salon.
11. All unused space throughout the boat should be readily accessible for use for stores. For example, under
the raised galley sole could be used for stores.
12. There cannot be too many handholds.
13. One white Hella turbo fan in the aft section of the galley and one in the sink area.