Instructions / Assembly

6
Operating the Cooktop
Ensure the cooktop is plugged into an electrical outlet. Place suitable cookware onto
the cooktop.
Main Power
Press the Power icon for three seconds. This powers on the whole cooktop.
You will hear a beep and see flashing lines - on the display next to all the burners.
Burners
To select the burner to use and the power level, press the burner icon for the desired burner.
You can change the power levels by sliding your finger across the slider or by pressing
a number.
Residual Heat Indicator
When the cooktop has been operating for some time, there will be some residual heat which
is indicated on the display as “H” .
Timer
Press the Timer icon to activate the timer. Each time the timer icon is pressed, an indicator
light around the icon illuminates, which indicates the position of the different burners. Once
the burner is selected, press the numbers on the control panel to set the number of minutes
to set the cooking time. The time will show on the digital display and the numbers will count
down on it as the time progresses. If more than one burner is selected, the time on the
display will be that of the least number of minutes.
To cancel the timer, press the timer icon to select the burner to cancel. Then press the
number “0” two times on the control panel. Or press the timer icon for 3 seconds and all times
for all the burners will be cancelled.
Note: Each burner on the cooktop is equipped with a safety temperature sensor which
switches off the cooktop if there is excessive heat. This is to protect the electronics from
overheating. Wait for the cooktop to cool down before using it again. If any cracks appear on
the surface of the cooktop, immediately disconnect it from the power.
If a cooktop is left on accidentally, it will automatically be switched off after a period of time
has elapsed.