EQUATOR Tumble Dryer Model: CL 837 V
INTRODUCTION UN@mˆˆšŒ”Š@sš„”‡„˜‡™ The dryer vents using a standard 4" duct that fits most dryer exhaust vents. Congratulations on your new EquatorVented Dryer. In addition to its award winning design, this is a highly sophisticated engineered product that will give you many years of satisfaction. Please spend a few moments to read the Owners Manual. This will show you ways to best utilize your valuable purchase.
Model CL 837 V Clothes Dryer The model number of your dryer (CL 837 V) can also be found on the serial plate, located inside the door. The Dryer Stacking Kit and other Spare parts are available for purchase or special order. For service, contact Equator Service at 1-800-776-3538 To request service and/or the location of the service agent nearest you, call the toll free number listed to the left.
INSTALLATION INSTRUCTIONS Exhaust Materials NOTE:To reduce the risk of fire, DO NOT use flexible plastic pipe to exhaust the dryer. The following exhaust materials are recommended and can be obtained from any local hardware store: 4.1 4"(Diameter) Rigid metal duct. 4.2 4"(Diameter) Non-combustable semi-rigid flexible metal duct. 4.3 IMPORTANT: For maximum efficiency, keep the exhaust duct as short as possible.Make sure old exhaust ducts are 'cleaned' before installing your new dryer. 4.
WALL INSERT OR RECESSED INSTALLATION 7.1 Warning! To reduce the risk of fire, this appliance must be exhausted outdoors. 7.2 Minimum clearances between the dryer cabinet and adjacent walls or other surfaces are: Sides Front & Rear 0" (0 cm) 3" (7.6 cm) 7.3 Make sure that the air inlets at the back are not blocked and do not allow fluff/lint to accumulate around the dryer CONTROL PANEL FEATURES A. START BUTTON To start the drying cycle Choose the final dryness of the B.
OPERATING INSTRUCTIONS TROUBLESHOOTING If the clothes are not dry after normal drying time: • Open the door. • Load clothes loosely into the drum. • Load sheets first,starting with one corner. • Close the door. • Dry your hands. • Plug in the machine. • Select the final Dry Cycle (see program chart on control panel for recommendations). • Press Start. The drum begins rotating in a counter-clockwise direction.
FOR PR ODUCT P AR TS & SER VICE CALL PRODUCT PAR ARTS SERVICE (800) 776-3538 Equator Corporation, Equator Plaza, 2801 W Sam Houston Pkwy N, Houston, Texas 77043-1611 Phone (800) 935-1955 • Fax (713) 464-2151 Printed in England. All rights reserved.
