Refrigerator Freezer WHD-423FSS1(D) WHD-423FWW1
1
6 7 1 2 8 9 3 4 5 PS: If we change some small parts of the refrigerator ,it is for you to use it more conveniently. Sorry for no giving notice.
Important Safety Instructions To reduce the risk of fire, electrical shock, or injury follow these basic precautions when using your refrigerator. DANGER: Risk of child entrapment. To avoid the possibility of child entrapment, please take the following precautions before you dispose of your refrigerator. o Remove all doors. o Leave shelves in place so children may not easily climb in. o Never allow children to play with, operate, or crawl inside the refrigerator.
Electrical Connection Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is damaged, have it replaced by an authorized service center. This refrigerator should be properly grounded for your safety. The power cord of this refrigerator is equipped with a three-prong plug which mates with standard three prong wall outlets to minimize the possibility of electrical shock.
NOTE If the unit is unplugged or loses power; you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this time delay, the refrigerator may not start. Replacing the Interior Light Before removing the light bulb, turn the refrigerator temperature control to the “1” position. Then unplug the electrical cord from the wall outlet. Failure to do so may result in electrical shock or personal injury. Replace the old bulb with a new bulb of the same wattage and size.
Care and Maintenance Cleaning Your Refrigerator x x x x x Disconnect the electrical unit from the wall outlet. Clean interior and parts with a cloth soaked in lukewarm water and baking soda solution. A solution of 2 tablespoons baking soda to a quart of water will clean and neutralize odors. Rinse and wipe dry. Be sure to keep the door gasket (seal) clean to keep the unit running efficiently. The outside of the refrigerator should be cleaned with a warm damp cloth and mild detergent.
Changing the Reversible Door Before reversing the door swing, ensure the appliance is unplugged and empty. Provide additional support for the doors while hinges are being removed. Do not depend on the door magnets to hold the door in place. It is recommended that two people perform this task. DO NOT lay the appliance completely flat as this may damage the coolant system.
Step 5 Step 6 Remove right pin assemblies from the bottom of the freezer and refrigerator doors. On the opposite side, attach the replacement pin assemblies (located in the plastic bag with the Use and Care Manual) with a screwdriver. Note: You must re-use the screws from the pin assemblies that are removed in this step when attaching the new assemblies. Place the refrigerator door on the bottom left hinge. Ensure the door is aligned horizontally and vertically.
Troubleshooting Guide You can solve many common refrigerator problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling for service. Problem Refrigerator does not operate Possible Causes Refrigerator is unplugged. The circuit breaker is tripped/ fuse blown. Compressor turns on and off The room temperature is warmer than normal Door is left open or is frequently opened.
