Super Combo ALL-IN-ONE COMBO WASHER (® DRYER Model: 4600 OWNER’S MANUAL Please read the instructions carefully and keep for future reference. Information may be updated from time to time so please refer to the manual online for the latest version of the manual.
Please read the Owner’s Manual carefully before using your ALL-IN-ONE COMBO WASHER ® DRYER 1 2 Technical Data 4 Important Safety Instructions. . 5 Helpful Hints -.c..ueiiiee IEEE rii err nnn rn mere 6 Pr-installation rea 6 Diagram of the COMBO 7 Installation INSTRUCTIONS sa 8 Unpacking and Leveling 9 Electrical .uuuiiuseiiinnss miss isi mania rein nna naan 10 PLUMBING 1 Ventilation iii rrr rrr Built-In, Recessed, Closet, Alcove Installation .
INTRODUCTION Congratulations on your new Super Combo! In addition fo its contemporary design, this Is a highly sophisticated engineered product that will give you many years of satisfaction. Here are some of the best reasons for buying your Super Combo 1. Space Saving By combining the two functions of washer and dryer in one unit, the space taken for the second unit, i.e. separate dryer, is saved. 2.
WARRANTY INFORMATION Your appliance is protected by this warranty under normal, personal, family or household use for 1 Year Parts & Labor and limited commercial use (90 days) in USA and Canada.
THE FOLLOWING WORK ARE NOT COVERED UNDER WARRANTY: a Installation 1. Non-removal of shipping bolts, causing vibration / infernal damage. 2. Non-adjustment of feet to level machine, causing vibration / internal damage. 3. Non-removal of exhaust vent plate at the back while using Venting Dry mode, causing excess heat and resulting in damage to internal components. 4. Not conforming to minimum space requirements for built-in installation, causing excess heat and resulting in damage to internal components. 5.
Warranty Limitations 1. If a unit is located more than 25 miles away, there will be a drip charge. 2. If a unit is in a remote area more than 75 miles away, the machine should be taken to the technician's workshop. 3. If the unit is installed in a 5th wheel RV, in a location behind the axle, it will not be covered under warranty. 4. All repairs or replacements are warranted only for the remainder of the original warranty period. 5. If a return or replacement is required, allow 3-4 weeks to process. 6.
] Type Front loading washer-dryer combo Model 4600 A. Width 23.6 /600 Dimensions B. Height-overall (inches / mm) C. Depth 21.85/ 555 D. Depth with door open Rated voltage 12A Water pressure (psi / Mpa) 1.00 Wash capacity (Ib / kg) 15/6.8 Dry capacity (Ib / kg) Max. 9/4.0 Net weight (Ib / kg) 160/73 Spin revolution Max. 1,400 rpm Washing 120 W consumption Spin s00wW ‘Wash heater 1,000 W Dry heater 1,300 W @.
IMPORTANT SAFETY INSTRUCTIONS Your Combo Washer @ Dryer has been built in compliance with safety regulation to protect you and your family. WARNING To reduce the risk of fire, electric shock, or injury to persons when using your appliance, follow basic precautions, including the following: Read all instructions before using the appliance. 2.
LA ‘The model number and ths serial number are on the A CAUTION A abs! afford to the back of the Unit. Chase numbers are also available on the front of the cabinet behind EE a fhe door LEE You should note th model and seal numbers of this unit in the space provided. Retain this booklet Ce THe permanent record of your purchase to ald In ov Back. WO Identification In the event of theft. Anglicanism PARTS Meme me Fer | oro PROFESSIONALS, SERIAL No: HELPFUL HINTS 1.
DIAGRAM OF THE COMBO WASHER &® DRYER Detergent Dispenser =1— Top Panel 7 Control Panel Drum Venting Fan and Cover Hot Eater Inlet Valve Leveling Feet J Tube Cap Drain Hosea Drain Tube Stinging Pump Filter Door Release Lover Factory supplied accessories 0 U-Connector Blanking Caps 3 Vent Adapter {For drain hiss) (To cover shipping bolts holey) (To connect vent hose to exhaust fan) Water Inlet Hoses
Handling Please handle the machine carefully and use appropriate means while lifting and moving the machine so that it does not get damaged. Do not drag the machine on your floor. Do not hold on to protruding parts when lifting. Disposing of the packing The shipping package has protected your new appliance on its way to your home. All packaging materials are non-pelleting and recyclable. Please dispose of packing material according to local environmental regulations.
UNPACKING, LEVELING & POSITIONING Remove the packing and check that the Super Washer is undamaged. If you have any doubt, do not use the Super Washer and call Customer Service. Keep all packing parts (plastic bag, foam rubber, screws, etc.) out of the reach of children since they could be dangerous. Important: The inside of the Super Washer consists of a free floating drum that is affixed with shipping bolts at the back of the cabinet during transport (Fig.1).
ELECTRICAL CONNECTION Connect the plug to a power outlet 110V / 80Hz with minimum 15 Amps. Make sure that the voltage and frequency available correspond with those stated on the serial number plate located on the machine. Do not use adapters or extension cords since they could result in overheating and bum out.
[UT] CONNECTING TO THE WATER FAUCET 1. Unscrew the adapter ring plate and the 4 adapter retaining screws. 2. Remove the guide plate if the tap is too large to fit the adapter. 3. Push the adapter onto the end of the tap so that the rubber seal forms a watertight connection. Tighten the adapter ring plate and the 4 screws. 4. Pull the connector latch plate down, push the inlet hose onto the adapter, and release ths connector latch plate. Make sure the adapter locks into place.
Dryer can be used in Vent less or Vented mode Icon for Vent less Icon for Vented VENT LESS (CONDENSING) Use dryer in Vent less Mode 1. ENSURE METAL VENT COVER (1) IS INSTALLED OVER EXHAUST FAN AS SHOWN IN FIG.8 2. Power on the machine 3. Press "Dry Only" button to set the machine on drying cycle. 4 5. . Hold Venturesomeness button for 5 seconds symbol will appear on the screen which confirms that the machine is in Vent less mode. 8. Press START to run dryer in Vent less mode. Fig.
WARNINGS MAXIMUM LENGTH OF THE VENT HOSE IS 10 FEET WITH THE 0.5 AMPS ORIGINAL EXHAUST FAN. USING LONGER VENT HOSE MAY DAMAGE INTERNAL COMPONENTS. FOR LONGER VENT HOSE USE 1.5 AMPS EXHAUST FAN, WHICH IS AVAILABLE AS AN ACCESSORY. DUE TO RISK OF FIRE USE ONLY METALLIC DUCT (RIGID OR FLEXIBLE). Never use flexible duct inside the dryer. Do not terminate exhaust in a chimney, range hood, gas vent, floor or attic. The combination of lint and grease could create a fire hazard or damages.
SPECIAL INSTALLATION REQUIREMENTS MINIMUM CLEARANCE OTHER THAN ALCOVE OR CLOSET INSTALLATION Minimum clearances to combustible surfaces: 2" (5 cm) clearance both sides and 3" (7.5 cm) rear. U1 N, RECESSED, CLOSET AND ALCOVE INSTALLATION The Combo Washer-Dryer may be installed in a built-in, recessed area, closet or alcove. The installation spacing is in inches and is the minimum acceptable. Other installation must use the minimum dimension indicated.
PROGRAM SELECTION CHART 1. WASH & DRY, WASH ONLY, DRY ONLY fast ms crises of saturates Hea! ar i bravura rox Time 1-NORMAL Mixed cottons | Warm / 1200 / 51 mind Max heat 1300W Thick cottons . Max heat 1300W 2 Prewash+Heavy (towels, jeans) Cold+Hot/ 1400 / 75 mind 120 mind Mixed cottons . Max heat 1300W 3 Heavy (shirts, jeans) | Hot/ 1400/81 mind 120 mind 4 -ECO Mixed cotton | Max heat 1300W Ix ns Cold / 800 / 31 mind 80 mind .
PET Cycle Before loading clothes and sheets into the appliance, remove as much pet hair as possible in order to prevent buildup and clogging of the drain pump. Wipe the surface of clothes and sheets with a lint roller or a damp rubber glove to easily remove pet hair. After the end of the wash cycle, run a quick wash cycle without clothes. After the cycle ends, wipe down the drum with a damp cloth to collect any pet hair on the drum surface. OPERATING INSTRUCTIONS 1.
4) Buttons Introduction [1] Wash @ Dry [2] Wash Only [3] Dry only (4) Color LED Display Vented / [5] Vents selection button (se) Delay Start{#) button If a change is to be desired program ag Program Dial (9) Start/Pause button Child Lock [11] Power To select Wash & Dry cycle together. To select Wash cycle only. For extra rinse, press and hold 1 + 2 together. To select Dry cycle only.
[EEE TTT LE Dry level options Sensor Dry Door Unlocked / Locked Chime On/Off Dry time/Remaining time. Venting Made: Only for wash settings Vent less Mode {Condensing} * An extra rinse can be added by pressing “Wash+Dry" and “Wash Only” at the same time. An Extra rinse and 9 minutes A. How to run WASH + DRY Cycle will be added to the cycle. 1. Press POWER button 2.
Add-a-sock Feature The wash program can be stopped at any time to add forgotten items to the laundry. Press START/PAUSE for 5 seconds. Door will open 2 mind after draining water so that it does not overflow. Load clothes. Close door. Press START The cycle will continue from the point it stopped How to stop the wash cycle The wash program can be stopped at any time.
MAINTENANCE Your Washer Dryer has been designed to operate with easy maintenance. Follow these simple maintenance procedures to obtain optimum performance: 1. Ensure that your machine was installed according to the compact installation procedures detailed In this Manual. 2. Do not use solvents either to clean the machine or to wash clothes. 3. Keep the inside of the detergent dispenser clean. Cleaning the coin trap Switch off the Washer Dryer Open the service flap. (bottom right comer) (Fig.
STAIN REMOVAL CHART Blood Rinse or soak fresh stain in cold water. Work detergent into any remaining stain. Rinse. If stain persists, put a few drops of ammonia on stain and repeat detergent treatment. Rinse. If necessary bleach. Burn Marks Rinse or soak in cold water. Work detergent into stain. Rinse. Bleach, if necessary. Stain may be impossible to remove. Candle Wax Scrape off excess. Place stain between clean white blotters or several layers of facial tissues. Press with warm iron.
Ink Some ball-point inks are set by water. First test a scrap of cloth. Sponge stain repeatedly with acetone, acyl acetate or rubbing alcohol. Hair spray is effective. Launder. Bleach if necessary. Use acyl acetate on triathlete, male, anodyne and revel. Use acetone on other fabrics. NOTE: Some inks cannot be removed. Ketchup Scrape of excess. Soak in cold water 30 minutes. Pr-treat with a detergent paste. Launder. Mildew Brush off surface growth to keep mold spores form spreading.
TROUBLESHOOTING In most cases, when your Washer@® Dryer fails to work, the problems arising can be easily solved without having to call for a technician. Before calling for assistance, always check these points.
[fontanel (ety yo 1 IV] DIAGNOSTIC MENU Code Description Component E1 Door open Door Switch E2 Drain failure Drain Pump E3 Water inlet failure Inlet Valves E4 | Water overfill Pressure Switch E5 Motor failure Motor +Electronic Module E7 Washing heater failure Washing heater E8 Dryer Malfunction Temp. sensor of tub) E9 Dryer Malfunction Temp. sensor {@front of heater housing} E10 | Water level failure Water level sensor E11 | Dryer Malfunction Temp.
