User Manual

35
The button inputs are not assigned to any
actuator channels in factory status (not the
actuator channels of the device on which they are
located either).
Assignment of button inputs to actuator channels
• Presstheprogrammingbuttonoftheactuator
(channel) to be assigned on the module until
the channel LED flashes slowly (after approx. 3
seconds). The module is now in teach mode.
• Now,actuateabuttononthebuttoninput(on
the same module or any other module on the
bus) that you want to assign to the actuator
(channel).
• Theactuator(channel)isnowassignedwith
this switch input and the channel LED goes
dark on the actuator.
• Testtheassignmentbypressingtherespective
button. The actuator (channel) should react
accordingtothecongurationofthebutton
input.
• Ifyouwanttoassignanotherbuttoninputto
the actuator (channel), repeat this procedure.