Operation Manual

24
The next switching time appears on •
the display (example shows 6:00).
Use the setting wheel to set the time.
Confirm with OK.•
Then, select a temperature for the •
selected switching time.
Keep repeating this process until you have finished storing •
temperatures for the period from 0:00 to 23:59.
After all 7 switching times have been selected, 23:59 will •
appear on the display as end time.
Confirm with OK.•
In Auto mode, the temperature can be modified at any time
via the setting wheel. The modified temperature will then
be retained until the next program changeover.
2. Weekly program: Examples
The energy-saving controller allows you to store up to 3 heat-
ing periods (7 switching times) with individual temperature
settings for each day of the week. The factory setting consists
of two heating phases (from 6:00 until 9:00 and from 17:00 until
23:00 respectively) for every single day of the week:
From 00:00 to 06:00 17.0°C
From 06:00 to 09:00 21.0°C
From 09:00 to 17:00 17.0°C
From 17:00 to 23:00 21.0°C
From 23:00 to 23:59 17.0°C
To represent the switching periods, the display shows
bars for every other switching interval. In this exam-
ple, no bars are shown for the interval from 0:00 to
6:00. Bars are only shown on the display for the in-
tervals from 6:00 to 9:00 and from 17:00 to 23:00.
If a room also needs to be heated at around noon, the cor-
responding program might look like this: